JavaScript seems to be disabled in your browser.
You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.
Molded from ABS-PolyCarbonate with a UV resistant matte paint finish, these pieces are sure to freshen up the look of your MKI MR2 and last for years.
Sold as a set of 3 pieces only and includes a kbox C-pillar rubber trim kit and new studs for the upper center piece.
These were modeled after the trim for cars with a 'Toyota' rain visor and the side pieces have 2 additional holes to locate the visor. If you do not have a visor, we will have 3D printed plugs available for these holes.
Images are of pre-production pieces. Actual shipped items may differ slightly in appearance.
Thanks for making this part! The plastic on the driver's side was just crumbling on my 87 t-top. The finish and heft is great - the fit is, as you say, quite tight, but doable. My Two has its self respect back ;-) I would def agree that gluing 4" lengths and allowing the trim to set is necessary. Also, removing the side covers makes it possible to use a full-sized screwdriver on the lowest screw. I wound up using a #2 square drive instead of a philips tip to keep from scraping the paint off the head. I also found it better for me to start with the lowest screw and work my way up. I have the toyota rear visor, and only going bottom to top allowed me to line that up. The top and passenger side (US) are pretty good on mine, so I have only put in the driver's side trim piece. I didn't have any trouble doing just that, but at some point I will do the rest, as I think the joints will match better. Thanks again for all the work of making this available!